光纤识别仪

Optical Fiber identifier(光纤识别仪)

1、General

Optical Fiber Identifier is an essential installation and maintenance instrument. By inserting the fiber into its adapter head, it can identify both Single mode and Multi mode optical fiber without any damage by detecting the optical signals being transmitted through them so as to avoid the opening of the fiber at the splice point for identification and thus avoids the interruption of the service. It is a perfect tool for the optical fiber solution.

2、Specification

3、Components

1. Optical Fiber Identifier-----------------------------------------------------------------1pcs
2. User Manual-----------------------------------------------------------------------------1book
3. battery-------------------------------------------------------------------------------------1pcs
4. Adapter------------------------------------------------------------------------------------4pcs

4、Function Direction

4.1 Panel Board

1.2 Feature

1. 1. Efficient identify the optical fiber direction and frequency(270Hz, 1 KHz, 2 KHz) without any interruption;
2. 2. Easy and convenient operation with a single keystroke;
3. 3. Provide corresponding adapter head for bare fiber、Pigtail etc;
4. 4. identify two kind of common signal frequency 270Hz, 1KHz, 2KHz;
5. 5. display the power size and signal strength in optical fiber;
6. 6. 9V battery、Low power、small size、convenient for operation;
7. 7. clarify and brevity LED indicator light;

4.3 Function Direction

1) Fixture Button

Push this button to clamping fiber tight, hold or release.

2) Indicator light

There are optical signal tramsmission direction indicator light,signal strength indicator light and transmission frequecncy indicator light,as n below,

5、Usage Direction

5.1 Adapter head

you can choose and match the right adapter head according to different bare fiber

or optical pigtail type:

5.2 clamp or release fixture

1. Please push up fixture button to clamp optical fiber,then press the front of fixture button,push down fixture button to make it minor rotation,to lock and hold the clamping head.

1. 2. when you release the optical fiber,please slightly push button forward,then press the rear of button,the fixture tool will release optical fiber automatically.

5.3 Switch On/Off

1. Push button forward, the identifier will be switched on automatically.
2. 2. Release the fixture button,it will be switched off automatically.

5.4 Optical fiber identifier

1. Put fiber into the trench,push button forward to lock fiber tightly.
2. If there is signal in optical fiber,the left and right light will the direction of signal,the signal light will the strength.
3. If there is no signal,the signal light will s the weakest signal and the direction light will flash to left or right,if no fibers,the direction light will flash to left or right as well.
4. 4. If the signal frequency is 2KHz,1KHz,270Hz,the related light will shine,ａnd accompanied by buzzer echo(when the signal is too weak,It will not identify correctly).
5. 5. Change fixture
6. Along with trench to slightly push the adapter head to left or right,to remove the current adapter head.
7. choose the corresponding adapter head with fiber.
8. Slightly push adapter head along with trench,untill it will be matched completely.